Many customers are not clear about the drug administration routes of automatic dosing machines. Today I will introduce them to you in detail:
1. Small-measurement calibration of drugs is added. The required amount of drugs is as small as tens of grams per minute, so ordinary natural gas flow meters are not suitable for properly detecting this flow rate. Based on the basic principles of throttle-type natural gas flow meters, natural gas with horizontal pressure is selected The flowmeter forms a detection device that can properly detect the total flow rate of this type of medicine. This product uses a pulse circuit to control the circuit relay to add the medicine.
2. Quantitative analysis of the dosing machine. The dosing range is 3.03000ml\/min, and the control error is ±3 percentage, such as adding 2 oil, butyl xanthate, kerosene and other commonly used drugs. The automatic dosing machine, based on PLC control, can be expanded to More than 200 units. It can be used for remote operation and automatic dosing. It can be widely used in all production processes such as mineral processing, drug flotation, and acquisition, plus quantitative analysis of liquid drugs.
3. Hydrated lime addition equipment for automatic dosing machines. At present, the hydrated lime added by automatic dosing machines in the pH adjustment of domestic flotation reagents has always troubled most domestic mining plants. The important reasons are: slaked lime has high impurity content, is prone to calcium deposition, and circulates It has poor corrosion resistance and strong corrosiveness. Mining plants mostly use manpower to add it, which not only consumes a large amount of lime powder, but also pollutes the environment. The pH value cannot be effectively controlled, affecting the flotation reagent indicators.
The above is the relevant knowledge about the drug administration route of the automatic dosing machine that the editor has shared with you. I believe everyone has already understood this. During the use of the automatic ball adding machine, it is necessary to check whether the ball mill is running and whether the ball mill is running. Interlock control is carried out at control points such as materials. If there is no interlock control between the ball mill and the ball adding machine, each rotates separately, the ball mill turns to add balls and the ball mill does not add, the ball adding machine adds balls and the ball mill does not turn, the application of the ball adding machine will be counterproductive. I believe that after everyone has a detailed understanding of these product knowledge, they can operate and use the product more reasonably and effectively.
