Solenoid valve dosing machine types and installation matters:
Typical solenoid valve
Internal thread steam solenoid valve
Model specifications: ZQDF
Caliber: small diameter
Material: carbon steel, cast iron, stainless steel
Flange steam solenoid valve
Model specifications: ZQDF
Caliber: small diameter
Material: carbon steel, cast iron, stainless steel
ZCM gas solenoid valve
Model specifications:ZCM
Caliber: small diameter, medium diameter
Material: carbon steel, stainless steel
Solenoid valve (normally closed)
Model specifications: US-F
Caliber: small diameter, medium diameter
Material: carbon steel
Special solenoid valve for water
Solenoid valve dosing machineThe precautions for installing the solenoid valve are as follows:
When installing, please note that the arrow on the valve body should be in the same direction as the material. It should not be installed in areas with direct leakage or water seepage. The solenoid valve should be installed vertically upward.
The solenoid valve should ensure normal operation within the power supply voltage fluctuation area of 15%-10% of the rated voltage.
After the solenoid valve is installed, there must be no reverse pressure difference in the pipeline. It must be plugged in several times to warm it up before it can be put into use.
The pipeline must be fully cleaned before the solenoid valve is installed. The incoming substances should be free of impurities. A filter device should be installed in front of the valve.
When the solenoid valve has a problem or is cleaned, a bypass device should be installed to ensure that the system can operate again.
